Difference between revisions of "MIDI"
(→Schematic) |
|||
| Line 27: | Line 27: | ||
[[Image:Midi-schematic.gif|thumb|400px|none|DSerial MIDI In/Out Schematic]] | [[Image:Midi-schematic.gif|thumb|400px|none|DSerial MIDI In/Out Schematic]] | ||
| − | Parts | + | Parts |
| + | *FOD260L optocoupler (3.3V, most other optocouplers are 5V...) | ||
| + | *1N4148 switching diode | ||
| + | *~1 kOhm resistor | ||
| + | *220 Ohm resistor. | ||
== Pictures == | == Pictures == | ||
Revision as of 04:55, 2 May 2007
Contents
Description
MIDI devices are very easy to connect to DS via DSerial. MIDI Out can be directly wired to the connector without any components. MIDI In requires to use an Optocoupler, but the schematic is quite simple.
The signal lines should be connected to DSerial CMOS-level UART at IO2 connector (do not use RS-232). Sending and receiving is done using the UART commands. Make sure to set baud rate to 31250bps as this is what MIDI is using.
Here is some sample code to send a note: <cpp> void midiWrite(u8 message, u8 data1, u8 data2) { u8 buffer[3]; buffer[0] = message; buffer[1] = data1; buffer[2] = data2; dseUartSendBuffer((char *) buffer, 3, true); /* blocking UART send */ }
/* then somewhere else do: */
dseSetModes(0); /* Disable RS-232 */ dseUartSetBaudrate(31250); /* MIDI baudrate is 31250 bps */
midiWrite(0x90, 0x11, 0x22); /* send a note to MIDI keyboard */ </cpp>
Schematic
Parts
- FOD260L optocoupler (3.3V, most other optocouplers are 5V...)
- 1N4148 switching diode
- ~1 kOhm resistor
- 220 Ohm resistor.
